browser icon
You are using an insecure version of your web browser. Please update your browser!
Using an outdated browser makes your computer unsafe. For a safer, faster, more enjoyable user experience, please update your browser today or try a newer browser.

Shed prep

Posted by on January 26, 2019
Electrical (and cable) prep

Electrical (and cable) prep

Our shed will be arriving soon – sometime in February, I think.  It will be plopped down on our site with no additional foundation work.  Four of the six hurricane tie-down points will be on pavers and two will be on grass.  I was initially concerned about this, thinking that the corner on grass might be vulnerable to settling.  And I might be right about that, but it seems to not be an issue for everyone else – the majority of the sheds in the park have one corner or more sitting on grass.  Besides, it is just a shed, so if I need to jack it up a bit I can do it myself with the 10-ton hydraulic jack that I carry with me wherever we go.

But some other prep work was needed.  We had to get the electric service run from the pedestal (and meter) on the right side of the site over to the left side, near where the shed will be.  We are going to need electricity in the shed.  More electricity than we need in the RV.  The shed will be wired for 80 amps or more while the RV has only 50.  The power is needed for the washer/dryer, the A/C and the on-demand water heater.

Our GC, Roger, said that a conduit is typically run under the site before the concrete is poured in anticipation of this.  But because our site was modified to have pavers instead of concrete and because the pavers were extended to be as wide as possible – wider than the typical concrete pad – he was concerned that he would have to dig up some pavers to find the end of the conduit.  Dollar signs started running through my head.  Fortunately, that turned out to be unnecessary as the marker for the end of the conduit was found hidden under a bush.

So Roger ran wire through the conduit and extended the conduit to the location where the back left corner of the shed will land.  He also ran the TV cable from the pedestal, through the bushes to the same location.  I was puzzled why he did this as I have no intention of watching TV in the shed.  But he said that residents typically put their cable TV modem and wireless routers in the shed.  Makes sense.  I am glad he took the initiative.

Maybe I can mount my third TV on the outside of the shed…

Leave a Reply

Your email address will not be published. Required fields are marked *